I am in France where my home is supplied with 3 phase electricity.
The voltage between phase is 400Vac and between phase and Neutral 230Vac.
I connected the OpenEVSE between Phase 1 and Neutral to obtain 230Vac on the OpenEVSE card and the current transformer on phase 1.
How do I tell the openEVSE that the load is on L1 / L2 / L3 / N?
Because the power values are not good.
OpenEnergyMonitor maintains EU specific firmware that replaced L1 and L2 settings with 1 Phase and 3 Phase.
Hi, thank you for this response,
Can you help me download firmware in openEVSE? I am looking for a procedure but I cannot find
Here is the guide for loading firmware.