Hello
I have just received and assembled my OpenEVSE terminal, purchased as a kit.
Everything is fine, but each time I start up I get a "GFCI Self Test Failed" and the charging station does not go into Start status.
If I disable the GFCI test, no problem, the charging station is in Start status.
I specify that the ground is of good quality.
I don't know if it's important, I'm in France, and I put myself in "Service Level 2" 240 V.
I tried reversing the 2 orange wires on the GFCI coil, as I saw on a forum, but it didn't change anything.
What can I do to activate the GFCI self-test?
Cordially,
Jean-Luc Ingrassia
Hello
I have just received and assembled my OpenEVSE terminal, purchased as a kit.
Everything is fine, but each time I start up I get a "GFCI Self Test Failed" and the charging station does not go into Start status.
If I disable the GFCI test, no problem, the charging station is in Start status.
I specify that the ground is of good quality.
I don't know if it's important, I'm in France, and I put myself in "Service Level 2" 240 V.
I tried reversing the 2 orange wires on the GFCI coil, as I saw on a forum, but it didn't change anything.
What can I do to activate the GFCI self-test?
Cordially,
3 people have this problem