Support
How can we help you today?
Programing new Atmega328P
3 CommentsSorted by Oldest First
OpenEVSE Support
said
over 4 years ago
I use this guide. Device is detected and start programing the fuses. After the fuses programing ther is no response from device. Any advice what to check? Can this be a problem with Xtal?
Sebuś
said
over 4 years ago
Show any commands you use.
Ivo boljšak
Hello,
By mistake I manage to burn my Atmega328P.
I bought and solder new one on the PCB can someone tell me what is the procedure to flash new chip to avoid to brick it due to fuses lock?