Hoping someone can provide me some guidance on how to install the MOV with the relay coil wires. I can't seem to fit both into the terminals. Thanks.
Barry S
1 Comment
G
Guido van Beek
said
about 7 years ago
I soldered the MOV under the board where the wires for the coil of the contactor are attached to the screw terminals ,there is not enough space in the holes of the terminals . It would be better if there was space on the circuit board for the MOV ,Guido
Barry Scherling
Hoping someone can provide me some guidance on how to install the MOV with the relay coil wires. I can't seem to fit both into the terminals. Thanks.
Barry S