How can we help you today?

Start a new topic
Discussions OpenEVSE Forums OpenEVSE Hardware

Help with Wifi Module

Just got the Wifi Module and am getting ready to install. Have a few questions before I start. I have the OpenEVSE v4.

1.   the Red (+) lead of UBEC Power module goes to the +12v header labeled RELAY 1/2, do you connect the black to the Grounding Bar or the Ground on the OpenEVSE ground where the ground cable goes. 

2.   Do you remove the R28 resistor when adding a wifi board and using the relay 1/2 as the power?


Thanks 

2 CommentsSorted by Oldest First

1. The Black wire can connect to any ground. Either the Ground on the board or the block is fine.


2. No need to remove R28 anymore. The UBEC uses the more powerful 12v feed.


 

1 person likes this

Chris, thank you so much for your reply.


Sal

Login or Signup to post a comment
More topics in OpenEVSE Hardware
See all 289 topics