Recently upgraded from the two-line LCD display to the 3.5 inch color LCD display.
My total energy consumption does not display correctly.
After installation of the new lid with new display, my total energy usage was 0.0 KWh.
After about a week of use, it's 57.6 KWh. And last session's usage shows as 0.0
However the old 2-line display used to show a several megawatts as I've used it for a few years.
If I enter RAPI and enter the command "GU" I get the following response:
> $GU < $OK 17626194 7279080^1B
That appears to translate to 4.9 KW last session and 7.3 MW accumulated. This seems appropriate.
Trying to manually set the counter results in the following response:
> $SK 0 < RAPI_RESPONSE_BLOCKED > $SK 0^2C < RAPI_RESPONSE_BLOCKED
I just wanna keep my high score.
My OpenEVSE is running firmware Ver 7.1.3 and my display/WiFi module is running Ver 5.1.2.
Theo Abramovich
Recently upgraded from the two-line LCD display to the 3.5 inch color LCD display.
My total energy consumption does not display correctly.
After installation of the new lid with new display, my total energy usage was 0.0 KWh.
After about a week of use, it's 57.6 KWh. And last session's usage shows as 0.0
However the old 2-line display used to show a several megawatts as I've used it for a few years.
If I enter RAPI and enter the command "GU" I get the following response:
> $GU
< $OK 17626194 7279080^1B
That appears to translate to 4.9 KW last session and 7.3 MW accumulated. This seems appropriate.
Trying to manually set the counter results in the following response:
> $SK 0
< RAPI_RESPONSE_BLOCKED
> $SK 0^2C
< RAPI_RESPONSE_BLOCKED
I just wanna keep my high score.
My OpenEVSE is running firmware Ver 7.1.3 and my display/WiFi module is running Ver 5.1.2.