Support

I have an open EVSE that boots properly. And displays the normal no EV connected on the LCD. When you plug a car in, the car beeps but the EVSE does nothing, remains in not connected. Anyone seen this or have advise?

I think i found my culprit. I have no continuity between pilot wire(EVSE end) and J plug side. I have taken handle apart to look into it but so far nothing. Anyone seen this?

so the issue ended up being a pinched wire in the J plug terminal.

I am having just this issue.   Car beeps but Charger still waiting.  I plan to check a pinout then verify connectivity to the correct pin in handle is missing.   I tested from the wiring block to the 1/8" exposed wire and it is good.

My issue ended up being an open circuit at the pilot...

I checked the wiring and the assembly drawings, and it seems my No Charging error was

that I missed connecting the control board to GND.  

When that was fixed, the error changed to "No Ground"

I confirmed that I have 220V + GND

I suspect I misunderstood the wiring of the low voltage part of the EVSE cable;

Is there a diagram showing the J1772 and where its pins should connect to the EVSE?

Or even just a diagram of J1772 that is confirmed.

Testing what I have according to one diagram suggests

that the diagram is not accurate, which is surprising.

Thanks

Update - Now the OpenEVSE says Connected when it is connected.   

Do I need to do something to start charging?

I tried pressing the Start button once, 

I tried holding the Start button.   Is this step documented?

Or is this a sign that I am not finished troubleshooting?

(Maybe the car is too full? :-)

Thanks!