Hi everyone frome Spain,
I have a old version board, the OpenEVSE PLUS DIY 30A, the one that has the 30A relays soldered on the board.
It's been working flawlesly for more than 3 years with my old Renault Zoe using the timer at 16A. Don't know what version it was cause I dont have the files anymore.
Now with my new VW ID3 I needed to upgrade to 32A so I changed the box, the IEC 62196 type 2 cable and connected the exit from the relays to control an external 32A contactor just to get those last 2 amps.
New box works ok but in order to get the 32A option on the settings I had to update the firmware (Only up to 30 option in the old one).
Now with 5.0.1 precompiled version I have the a problem with the timer. It sometimes works and sometimes not. Timer works (tested) but it doesnt charge always it stays on CONNECTED. When this happen disconecting the car and reconnecting is enough.
Manually charging with the button works perfect allways.
¿Any ideas? Thanks for your help.
In the meantime I'll try older version 3.10.4 and update the post.
Version 7.x does not have button menus, the settings are intended to be changed with WiFi. 7.x firmware should be paired with WiFi v 4.x.
If you wish to use button menus you should use Firmware 5.0.1 and WiFi 3.x
WiFi will work with your station.
Thanks for your answer.
Yes it could be. I just read some coments about that issue on the ID3 and the timer on other chargers, but never happened for two months before firmware change on the OPENEVSE.
About the OpenEVSE WiFi v4.x, can I load that to my board? Will it work? I tried version 7 and I couldnt access to the menu.
It sounds like the vehicle is falling asleep and is not responsive to the station. OpenEVSE WiFi v4.x has a workaround that puts the station in error state until the timer is ready.